Dermal Filler SCULPTRA 🍑

WHAT IS SCULPTRA?

SCULPTRA is poly-L-lactic acid (PLLA) in the form of a sterile non-pyrogenic freeze-dried powder with addition of sodium carboxymethyl-cellulose and non-pyrogenic mannitol. Synthetic L-polymer of polylactic acid belongs to the Alpha-Hydroxy-Acid (AHA) family.

INDICATIONS FOR TREATMENT WITH INJECTABLE POLY-L-LACTIC ACID SCULPTRA

SCULPTRA is an injectable implant. It is designed to combat facial fat loss (lipoatrophy) and indicated for correction of shallow to deep facial wrinkles and facial contour deficiency by stimulating your cells to produce their own collagen. The result gives a more youthful and natural-looking appearance.

SCULPTRA replaces lost collagen in the middle to lower face and chin area such as:

• Temples
• Nasolabial folds
• Tear throughs 
• Marionette lines 
• Pre-Jowl Sulcus or Pre-Jowl fold – a little known area on either side of our chin (see a picture on the right – the arrow points to Pre-Jowl Sulcus)
• Mandibular line – the jaw line that is usually more prominent and square among males.

It is also used for cheek augmentation and submalar volumizing.

During your SCULPTRA treatments, collagen growth is stimulated which allows you to gradually create a natural look that lasts up to 2 years.

FEATURES OF INJECTABLE POLY-L-LACTIC ACID SCULPTRA

SCULPTRA is a single use disposable device.

It is hypo-allergenic and gives excellent results.

ADMINISTRATION OF INJECTABLE POLY-L-LACTIC ACID SCULPTRA

SCULPTRA is a facial injectable that works gradually using a series of treatments. To produce a refined, more youthful appearance, an average of 3 injection sessions with 4 – 6 weeks interval between each session is required. 

SCULPTRA does not use any human or animal components, so no allergy testing is needed prior to treatments.

SCULPTRA is to be reconstituted with 5 mL of Water for Injection (available from Anna’s Cosmetics on request) at a minimum of 2 hours prior to use. The depth of injection and quantity of the product used depend on the treated area and the result expected. In general, SCULPTRA is injected into the deep dermis or subcutaneous layer with a 26G needle using cross-hatch injection technique (deep dermal grid pattern).

PRECAUTIONS

Do not overcorrect (overfill) wrinkles or the facial contour deficiency because they are expected to gradually improve during several weeks after injection.

Do not inject into the red area (vermillion) of the lip.

SCULPTRA should be injected into the deep dermis. Superficial injections may be associated with nodules and papules. Take special care when using SCULPTRA in patients with thin skin. 

SCULPTRA is a biocompatible and biodegradable material. It is produced by Sincalir Pharma.

ADDITIONAL INFORMATION ABOUT POLY-L-LACTIC ACID SCULPTRA 

Volume & Packaging: 1 x vial or 2 x vials

Accessory: Package Insert only. It is recommended to use a 26G needle (obtained separately) for injection.

Storage Conditions: Store up to 30℃. Upon reconstitution, it can be stored up to 72 hours at refrigeration (2-8℃) or room temperature up to 30℃. Do not freeze.

Note: Sterile packaging. This is a medical device class III and must be administered strictly by a health professional.

Buy other SCULPTRA injectable implants for correction of shallow to deep facial wrinkles on Anna’s Cosmetics!